Data Link Communications

Interface and Control Solutions
Welcome to DataLink

Your Source For Data Communications Equipment




Home

Back

 VIEW CART!   

DL-9SPOP2


RS232 Port Powered
Optical Isolator

9-Pin Port Powered RS232 Optical Isolator


This unit optically isolates both the RS-232 transmit and receive lines. The isolator has a DB9S female connector on the DTE side and a DB9P male connector on the DCE side. Signals pass through the isolator as shown.

When connecting the Model DL-9SPOP2, it is recommended that all signals that are outputs be connected. The Model DL-9SPOP2 derives power from these signals, even if they are not used by your system.

On a DTE device with a DB9 pin connector, the following lines are outputs: 3-TX (Transmit) 4 DTR (Data Terminal Ready) 7 RTS (Request To Send)

On a DCE device with a DB9 pin connector, the following lines are outputs: 1 DCD (Data Carrier Detect) 2 RX (Receive) 6 DSR (Data Set Ready) 8 CTS (Clear To Send)

Typical DTE devices include PCs, terminals, and printers. Typical DCE devices include modems and multiplexers. Most DTE ports are male and most DCE ports are female. If the 9SPOP2 is inserted into a working system, it will only pass signals if inserted correctly. If the devices communicate with each other without the 9SPOP2 inline, but not when it is installed, simply reverse the isolator.

If your port meets the low voltage requirements of RS-562, you will not be able to use this isolator. An RS-562 port will only produce about 3.7 volts, which is not adequate to power the isolator. Typically the only devices that have this type of port are palmtop or very low power laptop computers.

NOTE: Connecting an external power supply to the handshake lines may damage the isolator. Contact technical support for more information on connecting an external power supply to the handshake lines.

Specification
  • Transmission Mode: Asynchronous, half or full duplex, point-to-point
  • Interface: RS-232
  • Signals Supported: Transmit Data, Receive Data
  • Data Rates: 0 to 115.2K bps
  • Power Requirements: Port-powered from RS-232 data and handshake lines.
  • Isolation: 2500V RMS isolation for 1 minute
  • Dimensions: 6.1L x 3.3W x 1.7H cm

    DB25 units also available contact sales

    Price: €68.12








  • 9spop2_internal (15K)



    Contact:
    DataLink Communications
    Cloghaun, Kilchreest, Loughrea, Co. Galway, Ireland
    Email: sales@datalinkcom.net     Tel: +353-91-840838     Fax: +353-91-840839